Weldment Parts

Start with three sketches and add structural members

Structural Member (Weldments toolbar)

Second structural member

Trim/Extend

"discard" to toggles to "keep"

Extend vertical member

Trim other three rear end corners as above

Add End Cap

Add End Caps to bottom ends as above

Add Gussets

Add gussets to other three corners to arrive at picture below

Next, add Fillet Weld Beads

Add fillet beads to other three gussets

To hide weld symbols right-click Annotations in FeatureManager design tree and click Display Annotations

Sketch a new segment on top plane to add I-beam and change its Pierce Point (insert point)

Click Locate Profile

Incorrect corner treatments above were fixed too, see below.

Create a Sub-Weldment

Select eight items in Cut List

Save the new part file

End of tutorial