· Using Frame Generator
· Start new assembly drawing with default metric template and call it skeletal.iam
· Insert tool to insert skeleton profile with correct orientation using offsets and rotation angle
· Insert Components on sketch lines: tube, channel, angle with desired orientation
· Lengthen Profile of tube and allow 15 mm for fillet weld
· Notch Profile similar to Autocad 3d subtract command
· Mitre Joint with Mitre tool with clearance of 5 mm for groove weld
· Rebuild tool to undo and redo existing mitre
· Trim Profile with Trim To Frame tool
· Cut Profile with Trim - Extend To Face tool
· Profile Info with Frame Member Info tool
· Change tool to change member size with multi select
· Load Calculation with Design Accelerator Beam and Column tool
· Shorten sketch base length and view corresponding results in assembly drawing
· Start new assembly drawing and call it frame-hybrid.iam
· Insert Profile command to insert existing hybrid 3d sketch drawing.
· Insert tool for vertical channels one at time for different orientations
· DIN 59 370 S Angle Steel along base and top sketch profile lines using offsets and rotation angle
· Lengthen Profile command with exact calculated value
· Mitre joints with Mitre tool with 2mm clearance for groove weld
· Insert DIN EN 10219-2 Circular Hollow Section profile of desired size
· Orient profile using horizontal and vertical offsets and a rotation with desired insert point
· Cut profile with Trim - Extend To Face tool. Select items to cut, then face to trim or extend to
· Lengthen and notch profiles at their intersections
· Insert tool for DIN 59 370 S Angle Steel braces with point to point option
· Trim excess material with Trim - Extend To Face tool